Lure mold | CREATURE - B11

Making your own soft baits is now really easy!

Softbaits of different shapes and sizes are the basic equipment of every perch and zander fisherman, and now you can make your own fast and easy. Our selection includes molds from small fish to large pike rubbers.

The molds are made of artificial stone (a mixture of acrylic polymer and aluminum hydroxide) by CNC machining, and the quality is near aluminum molds in terms of detail and finish, but with a much cheaper price.

Instructions:

- Apply a thin even layer of mold oil to the mold, eg using a small brush, and close the mold with clamps.

- place the mold upright on the table and also place the handles of the clamp against the table to give it some extra stabilization.

- mix plastisol with colors and heat the mixture.

- suck the heated rubber mixture into the injector, and inject into the mold (glove in the hand you hold the injector with) with even pressure until you feel no more stuff goes into the mold, with smaller molds, this happens almost instantly.

- let the mold cool down a bit, then remove the finished lure from the mold and throw it in cold water.

- cut off the excess rubber, and small burrs formed at the points of the overflow channels.

- with one mold oil treatment you can pour 2-3 times, after that, just renew it.

By using the mold oil, you make sure that the finished lure does not stick to the mold and that the surface of the finished bait is shiny and smooth.