Bright Baits Liquid Plastic 5L
Price 79,00 €
- Varies by model
Liquid plastic, also known as Plastisol, is the stuff that softbaits are made of.
It comes in a liquid form and is activated by heating it to a certain temperature in a microwave oven.
Indicative Liquid plastic hardness selection:
Extra soft: micro jigs - small Perch jigs / small vertical jigs
Soft: small - medium size Perch / zander baits, medium - large vertical jigs
Medium: medium - large zander baits / vertical jigs, and small - medium pike rubbers
Hard: medium - large pike rubbers
The softer the rubber compound, the more lively the lure is, and the harder the rubber compound, the more durable the lure is.
1. Shake VERY well, it is important that ALL white and clear material is mixed together, otherwise, the hardness stated on the package will not be true in the finished lure. Check the bottom of the container against the light to see that no substance is left on the bottom after mixing.
2. Pour Plastisol into a microwave/heat resistant glass cup. You can make the base color of the lure and the back color of the lure in two separate cups and heat them at the same time.
3. Add a few drops of liquid plastic color at a time and mix gently with a mixing stick (DO NOT USE WOOD MIXERS!) to avoid unnecessary bubbles until the desired color tone is achieved. NOTE! Always write down how many drops of color you have put in, so that you can make lures exactly the same color later.
If bubbles form in the mixture during the mixing step, you can let the mixture stand for a while before heating.
4. Put the mixture in the microwave, adjust the power to 20-50% of the max power. Put on a protective mask at this point, the vapor from Plastisol is harmful/dangerous if inhaled. Slow heating with low power gives you a clear rubber compound without bubbles. Start by heating, for example, for about 1-2 minutes at a time and always check the rubber mixture between the heatings by stirring with a mixing stick. Reduce the heating time to about 30 seconds when the mixture starts to solidify (the mixture solidifies slightly before clearing). Liquid Plastic is ready to be poured (160-170c) when it vapors a little and by waving/mixing the cup it can be found to be a flowable and clear mixture. If the mixture is still sticky or cloudy, it must be carefully heated a bit more. NOTE! overheating may cause the mixture to burn, turning yellowish-brown/even black. For starters, you should use a digital thermometer with a long metal stick-shaped sensor when heating Liquid plastic, and as you gain experience you will learn when the stuff is ready to be poured.
5. Add the glitter and mix gently, you can also add the glitter before heating.
6. Treat the mold with mold oil to give a nice glossy finish to the finished lure surface, and also the rubber compound will not stick to the mold.
7. Now you can gently pour the mixture into the mold. NOTE! do not allow the previous layer of poured plastisol to harden/cool completely before the next layer is poured, otherwise, the layers will not "melt" together properly and may come off.
8. Depending on the size of the lure, allow to cool in the mold for 5-10 minutes before removing. You can then put the lure in cold water and let it sit there for about 15 minutes. The lure may absorb some water if it stays in the water longer and causes a slight clouding of the lure surface, but this effect will disappear from the lure after a while.
It is advisable to collect the solidified rubber material left at the bottom of the cup, so you can use them later by reheating.
9. GO FISHING!
Has the product or model you have been looking for run out of stock?
If the product or model you have been looking for is out of stock, subscribe to availability notification.